Trailer Hitch Installation - 2003 Mitsubishi Endeavor - etrailer.com

Description

www.etrailer.com Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information. Today we are going to be installing part number 75163 by Draw-Tite on a 2003 Mitsubishi Endeavor. We are underneath the vehicle now, and we are looking at the drivers side frame rail over here. The mounting location for the hitch on the drivers side is going to be the two weld nuts here at the base of the frame and then the two weld nuts here on the side of the frame, as well. On models that have seen at least one winter, a lot of times there is some corrosion built up in these weld nuts. So it is a good idea to go ahead and lubricate those first with a spray lubricant like WD-40 to kind of loosen up the rust and make it a little easier to get the bolts in there. So I am going to go ahead and do that on both sides of the vehicle. OK, and then, over here on the passengers side of the vehicle, again I am going to point out the mounting location. You have got two weld nuts here at the bottom of the frame which are kind of hard to see because the exhaust is in the way. And then again there is one here on the side of the frame. The first thing we want to do after again, I have already lubricated the nuts to let them soak a little bit while I go ahead and lower the exhaust, which is what we are going to do next we need to remove the rubber hangers. This one here, and then there is one over inside the wheel well, as well, that we want to go <b>...</b>

Keywords

etrailer.com etrailer, 75163, trailer, hitch, install, installation, receiver, 2003, 03, mitsubishi, edneavor, draw-tite, drawtite, hidden, reese, curt, valley

Related videos ^Experimental